STMicroelectronics STM32F746G-Discovery

Software Setup

Using the Pack Installer install the latest Keil::STM32F7xx_DFP pack and copy the example project CMSIS-Driver Validation (STM32F746G-Discovery) to your machine.

1. Choose one of the available Targets and build the project.
2. If you wish to test the loopback mode for some of the interfaces, refer to the next section for proper board configuration.
3. Run the validation on the target hardware using the on-board ST-Link/V2 debugger.

Hardware Setup

The following picture shows the necessary external loopback connections for the STMicroelectronics STM32F746G-Discovery evaluation board:

• SPI2: D12 (SPI2_MISO) and D11 (SPI2_MOSI)
• USART6: D1 (USART6_TX) and D0 (USART6_RX)
• For Ethernet use a loopback plug as described in Loopback Communication Setup.

Connections for Loopback Communication Tests on STM32F746G-Discovery