CMSIS-Driver Validation  
Driver Validation
 All Files Functions Variables Macros Groups Pages
Infineon XMC4500 Relax Kit

Software Setup

Using the Pack Installer install the latest Infineon::XMC4000_DFP pack and copy the example project CMSIS-Driver Validation (XMC4500 Relax Lite Kit) to your machine.

  1. Choose one of the available Targets and build the project.
  2. If you wish to test the loopback mode for some of the interfaces, refer to the next section for proper board configuration.
  3. Run the validation on the target hardware using the on-board JLink-Lite debugger.

Hardware Setup

The following picture shows the necessary external loopback connections for the Infineon XMC4500 Relax Kit evaluation board:

  • UART2: P0.4 (UART2_RX) and P0.5 (UART2_TX) (Header X2)
  • SPI0: P5.0 (SPI0_MOSI) and P5.1 (SPI0_MISO) (Header X2)
  • For Ethernet use a loopback plug as described in Loopback Communication Setup.
xmc4500.png
Connections for Loopback Communication Tests on the Infineon XMC4500 Relax Kit