Configure Transfers.
More...
Configure Transfers.
The DAP_TransferConfigure Command sets parameters for DAP_Transfer and DAP_TransferBlock.
DAP_TransferConfigure Command:
| BYTE | BYTE ******** SHORT *****| SHORT ******|
> 0x04 | Idle Cycles | WAIT Retry | Match Retry |
|******|*************|************|*************|
- Idle Cycles: Number of extra idle cycles after each transfer.
- WAIT Retry: Number of transfer retries after WAIT response.
- Match Retry: Number of retries on reads with Value Match in DAP_Transfer. On value mismatch the Register is read again until its value matches or the Match Retry count exceeds.
retry = Match_Retry;
do {
if ((Register_Value & Match_Mask) == Match_Value) break;
} while (retry--);
DAP_TransferConfigure Response:
| BYTE | BYTE **|
< 0x04 | Status |
|******|********|