Software Setup

Using the Pack Installer install the latest NXP::LPC55S69_DFP and NXP::LPCXpresso55S69_EVK packs and copy the example project CMSIS-Driver WiFi Inventek ISM43362 Validation (LPCXpresso55S69) to your machine.

Choose one of the available Project Targets and build the project.
Run the validation on the target hardware.

Note: The example is preconfigured to use an ULINKplus debug adapter.

This example is prepared for verification of the WiFi driver and it requires WiFi requirements, as well as, proper configuration described in WiFi Configuration.

For details on WiFi driver tests please refer to WiFi Validation.

Hardware Setup

This example uses the ISMART module with SPI communication.
By default, the shield is loaded with a UART firmware.
Instructions on how to flash the SPI firmware can be found in the CMSIS-Driver documentation.

For proper operation of the Inventek ISMART43362-E WiFi Shield please connect the jumper between 5V_BOARD and 5V_MOD pins on the WiFi Shield.

Note: Before running the validation on this hardware the WiFi Shield has to be reset by pressing SW2 push-button on the WiFi Shield and the debug session has to be started in less than 5 seconds after the reset push-button was released.

NXP LPCXpresso55S69 with Inventek ISMART43362-E WiFi Shield attached