Software Setup
Using the Pack Installer install the latest Infineon::XMC4000_DFP pack and copy the example project CMSIS-Driver Validation (XMC4500 Relax Lite Kit) to your machine.
- Choose one of the available Project Targets and build the project.
- If you wish to test the loopback mode for some of the interfaces, refer to the next section for proper board configuration.
- Run the validation on the target hardware using the on-board JLink-Lite debugger.
Hardware Setup
The following picture shows the necessary external loopback connections for the Infineon XMC4500 Relax Kit evaluation board:
- UART2: P0.4 (UART2_RX) and P0.5 (UART2_TX) (Header X2)
- SPI0: P5.0 (SPI0_MOSI) and P5.1 (SPI0_MISO) (Header X2)
- For Ethernet use a loopback plug as described in Loopback Communication Setup.
Connections for Loopback Communication Tests on the Infineon XMC4500 Relax Kit