Transfer data via UART.
More...
Transfer data via UART.
DAP_UART_Transfer (0x21):
Receive and Transmit data via target UART (only for transport via DAP).
DAP_UART_Transfer Request:
| BYTE | SHORT | SHORT | BYTE |
> 0x21 | Rx Count | Tx Count| Transmit data |
|******|**********|*********|+++++++++++++++|
- Rx Count: Maximum number of bytes to be read from UART receive buffer.
- Tx Count: Number of bytes in Transmit data to be transmitted.
- Note
- DAP_UART_Transfer command can be used only if transport via DAP is enabled.
-
If only receive is required, Tx Count can be 0.
If only transmit is required, Rx Count can be 0.
DAP_UART_Transfer Response:
| BYTE | BYTE | SHORT | SHORT | BYTE |
< 0x21 | Status | Tx Count | Rx Count | Receive data |
|******|********|**********|**********|+++++++++++++++|
- Status:
- Bit 0: 1 = Receive enabled, 0 = Receive disabled
- Bit 1: 1 = Data lost detected during receive (automatically cleared)
- Bit 2: 1 = Framing error detected (automatically cleared)
- Bit 3: 1 = Parity error detected (automatically cleared)
- Bit 4: 1 = Transmit enabled, 0 = Transmit disabled
- Bit 7..5: reserved (0)
- Tx Count: Number of bytes accepted from Transmit data and queued to UART transmit buffer.
- Rx Count: Number of bytes in Receive data read from UART receive buffer.
- Receive data: Bytes received from the target device via UART.